If only drivers were as attentive as sensor automation: the ever-moving intersection of needs and technologies has greatly increased the number of sensors in today's cars. Here are some of the latest sensor systems in cars today and in development for the future

Automotive Design & Production, June, 2005 by Lawrence S. Gould

EMISSION CONTROL

Automotive emission control systems essentially "breath" the dirty air from the engine to determine the engine's efficiency: fuel and engine efficiency can be determined by the oxygen concentration in the exhaust stream. Oxygen sensors are certainly not new, says Vishy Seetharaman, technical marketing manager for Delphi (Troy, MI; www.delphi.com). However, up to now, these sensors could only report whether the engine was running rich or lean, not how rich or how lean. The Delphi linear oxygen sensor can report the how. This sensor measures the air/fuel ratio of the exhaust gas from diesel and gasoline engines over a wide lambda (rich/lean) range. The five-wire, two-cell sensor combines new geometry (an integrated heater), different material sets (an alumnia/zirconia element), and an optimized membrane thickness to yield fast light-off and closed-loop operation. With such sensors, continues Seetharaman, vehicles can run closer "to the edge," which means getting more out of an automobile engine while reducing emissions even further.

[ILLUSTRATION OMITTED]

ADAPTIVE CRUISE CONTROL

Adaptive (or active) cruise control (ACC) systems can detect a vehicle ahead, detect both the distance to and the relative speed of that vehicle, and then maintain both the appropriate distance and speed between it and the car ahead. The latest ACC from TRW Automotive (Livonia, MI; www.trwauto.com) uses a 77-GHz radar sensor to detect vehicles up to 200 meters away. This system, which features range precision of 5%, speed measurement precision of 0.12 mph, and a search area of 12 degrees, is in the Volkswagen Phaeton and will be coming out in the new Volkswagen Passat.

But that's highway driving. In Japan, some cars are now being equipped for "low-speed following"; that is, drivers have highway-like cruise control capabilities on city streets, explains Jerry Bricker, vice president and general sales manager for Omron Automotive Electronics, Inc. (Novi, MI; www.omronauto.com). Note the differences here. In highway driving, a two-second gap between vehicles at 60 mph is roughly 150 feet (except, say, in Massachusetts). In city driving, there may be half a car length--six feet--between vehicles traveling under 25 mph.

Omron's new sensor, the Gen3 laser radar (lidar) sensor using Omron's micro lens array technology can handle both long- and short-range sensing. Wave pattern recognition technology in the sensor detects highly reflective light, such as that off vehicles, and poorly reflective light, such as that off pedestrians. The lidar's photodiodes receive and convert the reflected laser light into electrical signals. These signals are analyzed to determine reflectivity and, from that, the type of object ahead. The width of the Gen3 side direction detection is [+ or -]15 degrees; vertical direction detection is [+ or -]10 degrees.

VISUALIZING SAFETY

Lane departure warning (LDW) systems are just beginning to appear in cars. These video systems, explains Glenn Widmann, chief engineer of integrated safety systems at Delphi, use a camera situated behind the rear-view mirror. The camera looks forward and detects lane markers in the road. It then alerts the inattentive or drowsy driver when the car starts to swerve outside its lane. The 2005 Infiniti FX35 and FX45 SUVs and 2006 Infiniti M45 will have LDW systems.

Not surprisingly, automotive applications such as LDW, blind spot detection, and pre-collision warning are pushing video sensing technology. Consider, for instance, the Omron high dynamic range CMOS (HDRC) camera. Currently available as a prototype, this camera has a high dynamic range--over 170 db--and a high sensitivity--minimum 0.001 lux--which makes the system capable of' operating in a wide range of conditions, both bright and dark. The HDRC camera does not require an F-stop, shutter control, or an additional light source. It can detect images that are irradiated with near-infrared light outside the range of normal headlights.

[ILLUSTRATION OMITTED]

Cameras, says Widmann, provide good information about the width and angle to an object; radars provide very good range and velocity information. "Between the two, you can make a determination that an object is a pedestrian, a truck, or a road sign." (Camera-based pattern recognition provides the capability of recognizing objects, such as distinguishing a utility pole from a pedestrian.) Such camera-based systems linked to the vehicle's brakes are of particular interest to car makers in Europe and Japan. In those countries, versus the U.S., people tend to walk more and village streets are narrower and not as well lit. Hence the interest in technologies for pedestrian safety systems. In the future, adds Widmann, these same systems might be able to read the speed limit on road signs and, with the ACC system, adjust the car speed appropriately.

INSIDE APPLICATIONS

Occupant sensing seeks to determine two things, explains Peter Suh, North America product manager for TRW's Electronics & Restraint Systems: the size and location (especially the head). This is important for disabling an airbag if a small child is in the seat, or to create a more tailored restraint system by deploying the airbag to a different size or pressure.