Rebar bender/ cutter includes microprocessor - new products - advertisement
Masonry Construction, July, 2002 by Jim Camillo
The VB16Y rebar bender/cutter features a built-in microprocessor that enables the unit to uniformly bend 3/8-, 1/2-, and 3/8-inch-diameter rebar up to 180 degrees. A variable-speed trigger switch lets the operator control the bending speed with precision. The product weighs 37.5 pounds, cuts rebar in 3.1 seconds, and bends it in 5.1 seconds. Reaction receivers at the front and rear combined with the unit's low-profile design helps keep the tool still when bending long rebar.
* Hitachi Koki USA Ltd., 3950 Steve Reynolds Blvd., Norcross, GA 30093; 770-925-1774; www.hitcahi.com/powertools
circle 9 on the reader service card
COPYRIGHT 2002 Hanley-Wood, Inc.
COPYRIGHT 2003 Gale Group
Most Recent Business Articles
- Multiple criteria evaluation and optimization of transportation systems
- Multi-criteria analysis procedure for sustainable mobility evaluation in urban areas
- A two-leveled multi-objective symbiotic evolutionary algorithm for the hub and spoke location problem
- Multi-criteria analysis for evaluating the impacts of intelligent speed adaptation
- The development of Taiwan arterial traffic-adaptive signal control system and its field test: a Taiwan experience
Most Recent Business Publications
Most Popular Business Articles
- 7 tips for effective listening: productive listening does not occur naturally. It requires hard work and practice - Back To Basics - effective listening is a crucial skill for internal auditors
- FAS 109: a primer for non-accountants - Financial Accounting Standards Board's "Statement 109: Accounting for Income Taxes"
- LIFO vs. FIFO: a return to the basics
- Too Young to Rent a Car? - 25-years-old the minimum age for car renting - Brief Article
- Design a commission plan that drives sales - Sales Commissions
Most Popular Business Publications
Content provided in partnership with
